FAQs

CNC laser follower always hits the board during in following movement

(Q)CNC laser cutting machine follower always hits the board during in following movement 
 
(A)  Too small calibration range or too large Z-axis speed

The smaller the calibration range, the smaller the deceleration distance of following movement. If Z-axis speed is too large and it is not reduced to 0 when the follower flows to place, overshoot will be unavoidable. The greater the Z-axis speed is, the greater the overshoot is. When Z-axis speed is greater than 100mm/s, it is recommended to set the calibration range to be 15mm. When Z-axis speed is greater than 250mm/s, it is recommended to set the calibration range to be 20 to 25mm.

Add comment

Call. +86-10-51662600
Email. info@steeltailor.com

Cannes Industrial Park, No.18 Shuang Qiao Dong Lu, Chao Yang District

Beijing ,China. 100121


 

Customer Center