Home >CNC Cutting Machines >Manual >Power

Power Seires - cnc cutting machines

SteelTailorTM Power Portable CNC cutting machines User's Manual

7.6.4. SYSTEM parameters
Press 【F2】SYST and the interface of SteelTailor CNC portable Cutting Machine is shown as below:
cnc cutting machine
picture-cnc cutting machine
1. NUM/DEN: NUMERATOR/DENOMINA----The ratio that electronic gear numerator and denominator is Pulse Equivalent*1000. For example: if system’s Pulse Equivalent is 0.008mm, the electronic gear numerator/denominator =8/1.Electronic gear ration formula: N/M= Lead Screw Pitch*1000/(360*Detail Segment/Stepping angle* Gear Ratio)
2. MA-ORIGIN-----Machine tool origin, it is a special point set by approach switch. If the values of Mechanical Home Position haven’t been set, you can set it for zero.
3. REFERENCE-----Reference point. It’s defined as the cutting start point, and it is specified by G92 order.
4. CLEARANCE-----Reverse Clearance compensation. When the direction of the torch is changed, this clearance should be compensated if the SteelTailor CNC portable Cutting Machine has reverse clearance. The value should be measured (unit: mm).
5. OFFSET ----Marker Offset. The offset between the marker and torch axis;
6. POSI LIMI /NEGA LIMI: SOFT LIMI+/SOFT LIMI----Soft Positive Limit and Soft Negative Limit. If the torch’s coordinates out of the set scale, the system will alarm. The parameters set are over actual used value if unavailable.
7.6.4.1. Procedure
1. Press 【F3】PARA
2. Press 【F2】SYST
3. Input the value X of NUMERATOR
4. Press 【ENTER】
5. Input the value Y of NUMERATOR
6. Press 【ENTER】
7. Input the value X of DENOMINA
8. Press 【ENTER】
9. Input the value Y of DENOMINA
10. Press 【ENTER】
11. Input the value X of MA-ORIGIN
12. Press 【ENTER】
13. Input the value Y of MA-ORIGIN
14. Press 【ENTER】
15. Input the value X of REFERENCE
16. Press 【ENTER】
17. Input the value Y of REFERENCE
18. Press 【ENTER】
19. Input the value X of OFFSET
20. Press 【ENTER】
21. Input the value Y of OFFSET
22. Press 【ENTER】
23. Input the value X of SOFT LIMI+
24. Press 【ENTER】
25. Input the value Y of SOFT LIMI+
26. Press 【ENTER】
27. Input the value X of SOFT LIMI-
28. Press 【ENTER】
29. Input the value Y of SOFT LIMI-
30. Press 【F6】 SAVE
Notes: